Cisco katsetused

Sissejuhatus

Eesmärgiks on antud juhul üks väike cisco ruuter seadistada NAT ja DHCP teenuseid pakkuma.

If you have Used Router (not a brandnew Router) to work with, and you want to follow along with this tutorial, you can blank out everything, and start from what we call, "A Clean Slate".

(A Clean Slate refers back to a time when students wrote on slabs of rock)

Type in the following two Commands from the Enable Mode:

enable 

Erase Startup-config 

Reload 

DO NOT do these two commands on your company's production routers! This will have very BAD consequences - i.e. "Network Down, You Fired!"

Peale seda masin stardib. Ja järgmisena tuleb basic konf initsialiseerida

Minul peale seda tekkis selline konfig

The following configuration command script was created:

hostname Router
enable secret 5 $1$VCFk$7345345kkqn93459xy./
enable password parool
line vty 0 4
password parool
snmp-server community public
!
no ip routing

!
interface Ethernet0
shutdown
no ip address
!
interface Ethernet1
shutdown
no ip address
!
interface Serial0
no shutdown
no ip address
!
end

Lingid

Cisco IOS on väga võimalusterohke operatsioonisüsteem. Sellekohta on cisco andnud välja väga ohtralt ametlikku materjali. Neid siin äratooma ei hakka pigem mõned alternatiivsed viited.

http://www.pimpmynetwork.org/basic_cisco

http://www.fantek.org/cisco/wpbascom.htm

http://www.velocityreviews.com/forums/t41103-basic-cisco-switch-tutorial.html

http://geek.pandemonium.de/2005/07/09/dhcp-server-on-a-cisco-1605/

http://www.dslreports.com/faq/11037

http://www.cisco.com/warp/public/109/config_nat_on_cm.html